Emergency decontamination wipe – DecPol®

Polyvalent wipe for emergency decontamination of surfaces, equipment, and skin. Through the combination of a superabsorbent material and specific catalysers, DECPOL wipe can :

  • Decontaminate more than 99% of chemical and biological agents by transfer
  • Destruct the contaminants absorbed in the wipe
  • Reduce cross contamination risks and contaminated powder  release.
  • Does not cause overcontamination.

DECPOL wipe is intended for dual use: Defense, First-Responders, and Industry.

DECPOL wipe is a simple, fast and effective solution in case of chemical and biological contamination, which avoids cross-contamination.

Technical data
Material’s absorption capacity> 600 %NF T 90-361
Surface decontamination factor by transfer:
HD> 99%According to NATO Standard STANAG 4653
PR NF X 52-123
VX> 99 %  According to NATO Standard STANAG 4653
PR NF X 52-123
GD> 99 %     According to NATO Standard STANAG 4653
PR NF X 52-123
Biological agentsAccording to NATO Standard STANAG 4653
PR NF X 52-123


Destruction :
Destruction of chemical agentsTested on HD, VX, and GD
Destruction of biological agents

     1. Absorption by capillarity:

Fast transfer of contaminants within microfibers. The contaminants will then diffuse throughout the thickness of the hyperabsorbent material, allowing an optimal contact with the catalysts already present in the material.

     2. Destruction of chemical and biological contaminants:

Catalysts are distributed homogeneously throughout the thickness of the hyperabsorbent material. They will thus enable decontamination of the chemical agents, and disinfection of the biological agents.
Degradation by-products are not toxic.
     3. Non-aerosolization:

Its physical design makes it possible to optimize its efficiency and prevents any release of toxic. DEC’POL® therefore avoids the risks of cross contamination by limiting the release of powder and powder inhalation that may contain toxic substances.

  • AEP 58
  • AEP 7
  • NF X52 123
  • NF X52 122
  • NF T 90-361

Instructions for use:

  1. Identify area of contamination
  2. Apply firmly during 1 second, then wipe a secnod time with the 2 nd side
  3. After use, follow procedure for contaminated waste disposal.